Checkpoint Systems Inc. CP11 Manual De Usuario
T E S T I N G P R O C E D U R E S
14
To maximize the system’s performance, it is important to test it at the start of each business day. For best results,
use the same test procedure each day.
use the same test procedure each day.
To test the system properly, walk completely through the pedestals while holding a test tag at waist level. (The
test tag is included inside your Checkpoint Welcome Package). Waving the test tag alone between the pedestals
will not provide a true reading.
test tag is included inside your Checkpoint Welcome Package). Waving the test tag alone between the pedestals
will not provide a true reading.
If you are experiencing detection problems when using the test tag with the sensing system, please
check the following before placing a service call:
check the following before placing a service call:
1. Is the power supply (the silver box mounted near or below the cash register) plugged in and
turned to the “on” position?
2. Is the power supply light on?
3. Did you check the circuit breaker? This is located on the back of the power supply opposite the
black power cord. If the small button is sticking out, hold it in for three to five seconds, then check
the system again with the test tag.
the system again with the test tag.
If problems persist, contact Checkpoint’s Service Department at (800) 253-7580 to place a service call.
When placing a service call, please give store name and customer number (if available), along with a
brief description of the problem you are experiencing.
When placing a service call, please give store name and customer number (if available), along with a
brief description of the problem you are experiencing.
*
For testing your deactivation unit, please refer to your store management or Checkpoint sales
representative for proper procedures.
representative for proper procedures.