Securifi Ltd. SC1 Manual De Usuario
Almond Click QSG
SC1
1. LED indicator
2. Push button
3. CR 2032 battery
4. Join/Reset/Tamper button
5. Lanyard hole and groove
2. Push button
3. CR 2032 battery
4. Join/Reset/Tamper button
5. Lanyard hole and groove
English
Adding an Almond Click
Step 1: Remove the back cover by pulling the back cover upwards at the groove provided in
the lanyard hole.
Step 2: Tap the “Add Sensors” icon on the LCD UI of your Almond router and tap on “Add” to
start the adding process.
Step 2: Press the join/reset button on the back of the Almond Click.
Step 3: Insert the battery into the battery holder on the back of the Almond Click while the
join/reset button is kept pressed. The LED indicator on the front will start blinking. This
indicates that the Almond Click is being added to your Almond router.
Step 4: Wait for the Almond router to finish adding the Almond Click. You will see a message
that the sensor has been added. Enter a name and location for the sensor and tap on
“Done”.
Step 5: Snap the back cover on to the Almond Click. Make sure that the lanyard holes in the
body of the Almond Click and the back cover are lined up.
Step 6: On the Almond LCD, go back to the “Home” screen and tap on “Connected Sensors”
and tap on the sensor you just added. Next tap on “Tampered” to reset the tamper switch.
the lanyard hole.
Step 2: Tap the “Add Sensors” icon on the LCD UI of your Almond router and tap on “Add” to
start the adding process.
Step 2: Press the join/reset button on the back of the Almond Click.
Step 3: Insert the battery into the battery holder on the back of the Almond Click while the
join/reset button is kept pressed. The LED indicator on the front will start blinking. This
indicates that the Almond Click is being added to your Almond router.
Step 4: Wait for the Almond router to finish adding the Almond Click. You will see a message
that the sensor has been added. Enter a name and location for the sensor and tap on
“Done”.
Step 5: Snap the back cover on to the Almond Click. Make sure that the lanyard holes in the
body of the Almond Click and the back cover are lined up.
Step 6: On the Almond LCD, go back to the “Home” screen and tap on “Connected Sensors”
and tap on the sensor you just added. Next tap on “Tampered” to reset the tamper switch.