LADD IP Holdings Pty Ltd atf BMT IP Discretionary Trust A310500V5R1 Manual De Usuario
BMM
®
System
Manual
– BMM Activator
1
www.bmt.com.au
1
I
NTRODUCTION
Blast Movement Monitors (BMM
®
s) are delivered to site with the transmitter in a low power
hibernation state. The BMM
®
transmitter must be switched on before installation into the
blast.
The BMM
®
can only be switched on by a specially coded signal which eliminates accidental
activation. The BMM
Activator (Activator) is a remote control device that provides the signal
to turn a BMM
®
on and to also assign a delayed start-up time if required. It is also useful to
quickly determine if a BMM
®
is transmitting.
The signal from the Activator is low power to limit its range to approximately 0.5 m. This is to
control which BMM
®
s are switched on.
WARNING
All BMM
®
s that are within range of the Activator will
switch on when the BMM On button is pressed. Ensure
other BMM
other BMM
®
s are well out of range (several metres to be
certain) of the BMM
®
to be turned on or programmed. Do
not play with the Activator anywhere near BMM
®
s.
Store BMM
®
s in a separate location to the Activator
2
U
SING THE
BMM
ACTIVATOR
2.1
Hardware
The Activator consists of a tough ABS plastic case with a
sealed low-profile keypad. The battery compartment can
be accessed by pressing and sliding a section at the back
of the case. Use a good quality 9 V alkaline or
rechargeable Nickel Metal Hydride (NiMH) battery.
sealed low-profile keypad. The battery compartment can
be accessed by pressing and sliding a section at the back
of the case. Use a good quality 9 V alkaline or
rechargeable Nickel Metal Hydride (NiMH) battery.
The BMM
®
System kit is supplied with an Aquapak. It is
a transparent case that is 100% waterproof when closed. It
has a cord for hanging around the user’s neck, which
frees up hands for other tasks and eliminates the chance
of dropping the Activator into a blast hole.
has a cord for hanging around the user’s neck, which
frees up hands for other tasks and eliminates the chance
of dropping the Activator into a blast hole.
It is strongly advised that the Activator be placed inside the supplied
Aquapak and hung around the user’s neck.
Aquapak and hung around the user’s neck.