CLUB3D SenseVision MST HUB 1-3 DisplayPort CSV-5300 Prospecto

 

While we endeavor to provide the most accurate, up-to-date information available, the content on this document may be out of date or include omissions, inaccuracies or other errors. Therefore Club 3D does not accept any rights claimed on the content of this docu-

ment. Please refer to a full overview of our Legacy Terms and Conditions on www.club-3d.com. All other brand names are trademarks or registered trademarks and are the property of their respective owners. All content is subject to change without prior notice.

Club 3D B.V. PO Box 599, 2130 AN Hoofddorp, The Netherlands

www.club-3d.com

Multi Stream transport Hub  100g 

78.2*60.5*18.6 mm

1. Easy configuration for adding three displays and 

    does NOT require active adapters (DP++ compliant)

2. Perfect multi monitor solution on a budget. Plug 

    and Play.

3. Hot plugging. Does not require shutting down the 

    system.

4. Compatible to all existing DisplayPort graphic cards 

    and notebooks

1

5. Best with AMD Radeon™ Graphics

2 

6. Best with AMD A-series APU’s

3

7. AMD Eyefinity Technology ready

4

Leveraging the micro-packet architecture of DisplayPort™, DisplayPort™ 

1.2 adds the capability to address and drive several display devices 

through one DisplayPort™ connector. This feature has often been 

referred to as daisy-chaining or addressable displays.

The Club 3D MST hub is a hub device that receives a DisplayPort™ 

1.2 MST signal from the source device and splits up and routes the 

video streams independently to each display device. Using this type of 

configuration also allows the use of non DisplayPortTM 1.2 monitors. 

Non DisplayPort™ outputs, such as VGA, DVI or HDMI®, the Club 3D 

MST hub is DP++ and can actively convert the DisplayPort™ signal to 

the other types of display interface signals.

Multi-display Technologies DisplayPort™ 1.2, a new display interface, 

boasts features such as tremendous bandwidth and daisy-chaining 

capabilities. Combined, these features complement the AMD Eyefinity 

technology multi-display technology very well.

The new MST hub display technology is part of the ecosystem in the 

Club 3D AMD Radeon™ graphic cards.

Supported graphic cards can be found on the following AMD RAdeon 

series:

CAC-1053 - DP to HDMI 3D

- Standards compliance/support:displayport v1.2, displayport v1.1a,VESA DDM 

- Standard,HDCP V2.0,DisplayId,and EDID V1.4 

- Supports main link rates of 5.4 bps(HBR2),2.7 bps(HBR)and 1.62 bps(RBR) from source 

- Supports 1/2/4 lanes of main link for RX side 

- Supports three DP++ output port,or two dual-link DVI ports,or the combination of ports 

- For DP 1.2 source,supports DP1.2 MST multi video/audio steams 

- Supports 1.1 source,supports ViewXpand 

- Supports DP-DP Bypass mode 

- Supports AUX-CH enables SBM and I2C mapping over AUX between the source/sink and 

   device 

- Dedicated I2C slave for main processor to access the device 

- Supported output resolution:up to 2560X1600@60Hz each monitor in DP1.2 MST and up to 

   FHD/1080p in DP1.1 or DP 1.2 SST 

- Input pixel data depth 6/8/10/12 bits and supports output pixel format RGB444