APC NetBotz 320 Rack Appliance NBRK0320E Manual De Usuario

If the selected item features a large number of sensors, the sensors may also be divided into sensor sets. 
Sensor sets enable you to filter the contents of the Sensor Data pane to display only sensors that are 
associated with a specific interface or portion of the selected device. To display all of the sensors included 
in the selected device select All Sensors from the Set drop-box. To view only the sensors associated with 
a sensor set, select the desired sensor set from the Set drop-box.

 Located on the right-hand side of the interface, the Action/Information pane contains a series of buttons 
that enable you to view information and perform configuration tasks on your appliance and pods. Each 
button, when selected, presents a different panel in the Action/Information pane. The following panels are 
available from the Action/Information pane: 

• Camera View: Displays the images currently being captured by any integrated camera (NetBotz 

320 and 420 only) or Camera Pod 120s or CCTV Adapter Pod 120s connected to the appliance. 
Also enables you to listen to an audio stream from a selected Camera Pod 120 or CCTV Adapter 
Pod 120. If relay outputs are associated with any of your camera pods (“Associating Relays or 
Switches with Integrated Cameras and Camera Pods” on page 68) then buttons that correspond to 
each associated switch or relay will appear on the camera image to which they correspond.

• Alerts View: Displays alerts that are currently being reported by the appliance, any pods that are 

connected to the appliance, or any devices that are being monitored using Device Crawlers. Alerts 
that have recently occurred, but which have been resolved, can be shown as well.

• Maps View: Displays maps that have been configured for use with this appliance. The alert state of 

all devices shown on the Map View are indicated with simple color coding (red indicates that an 
alert state currently exists, while green indicates that no alert state is currently being reported by the 
sensor or device). The Map View is available for use only on appliances for which the BotzWare 
Premium Software Module 2.4 has been purchased.The BotzWare Premium Software Module is 
available as part of NetBotz Extended Warranty Coverage. For more information, contact your 
NetBotz authorized reseller or the NetBotz support team.

• Graph View: Displays a graph of up to 24 hours of environmental data that has been collected from 

any sensor that is connected to the NetBotz appliance (including sensors that are built into pods, 
external sensors connected to Sensor Pod 120s, devices that are being monitored using Device 
Crawlers, RS232-based sensors that are connected to your appliance using a USB-to-serial-port 
adapter, and relay-based devices connected to Output Relay Pod 120s).

• Configuration: Enables you to access the configuration tasks that are available for your appliance, 

as well as any pods that are connected to the appliance or external sensors that are connected to your 
pods. Also enables you to configure Device Crawlers to monitor additional devices. 

• About: Displays information about your appliance and all connected pods.

The air flow sensor, integrated in the Sensor Pod 120, must accumulate up to 3 
minutes of sensor data before it can provide accurate air flow sensor readings. 
After the Sensor Pod is powered on, air flow sensor data will appear as “N/A” 
until enough data has been collected.