Ideal Networks Serie 33-960 Cable tester, cable tester 33-960-3 Manual De Usuario
Los códigos de productos
33-960-3
34
IDEAL
Setting Storage Parameters
Setting Storage Parameters
Each time you save a trace, the unit suggests a file name based on
autonaming settings. After saving a result, the unit prepares the next file
name by incrementing the suffix.
autonaming settings. After saving a result, the unit prepares the next file
name by incrementing the suffix.
File names: maximum of 20 characters for prefix and 3 digits for suffix.
By default, traces are saved in native (.trc) format, but you can configure
your unit to save them in Bellcore (.sor) format.
your unit to save them in Bellcore (.sor) format.
Note: If you select the Bellcore (.sor) format, the unit will create one trace file per
wavelength (for example, TRACE001_1310.sor and TRACE001_1550.sor, if
you selected both 1310 nm and 1550 nm for your test). The native format
contains all wavelengths in a single trace file.
you selected both 1310 nm and 1550 nm for your test). The native format
contains all wavelengths in a single trace file.
To set the autonaming scheme:
1. Press Menu, select Setup > OTDR, and then
1. Press Menu, select Setup > OTDR, and then
press Select.
2. Use the left/right function arrows until you
see Storage, and then display the pane
(F1/F2 key).
(F1/F2 key).
3. Use the up/down arrows to select File name prefix or File name
suffix.
(for details about using
keyboards, see Using Menus and Keypad on page 13).
5. Enter the name (prefix) or number (suffix), and then press OK
(F1/F2 key) to hide the keyboard.