Dynamode 100BaseTX to 100BaseFX Fibre Optic Converter TT100-TF100SC Prospecto

TT100-TF100SC is a Fast Ethernet 

100Base-TX to Fiber 100 Base-FX 

converter. It features one fiber port with 

SC, ST,MT-RJ or VF-45 connector and 

one twisted pair port with RJ-45 

connector. It converts electrical signal 

from 100Base-TX side into optical 

signal at 100Base-FX side and vice 

versa. The TT100-TF100SC series 

converter can be used as a standalone 

unit or as a slide-in module to the 19" 

converter rack (up to 10 units) for use 

at a central wiring closet. 

Standard

Connectors

Data transfer rate

Dimension (mm)

Power requirement

Ambient  Temperature

Humidity

Cable 

IEEE802.3u Fast Ethernet 100Base-TX 
and 100Base-FX standards 

TT100-TF100XX RJ-45 and ST/SC/VF45/MTRJ 
connector (Multi-mode) 

100Mbps

26mm(H) x 71mm(W) x 97mm (D) 

1A+5V

 5%C~90%C

 5°C ~ 50°C

UTP : Cat. 5 UTP cable 
Fiber : 50/125, 62.5/125, 100/140m multi-mode 
8.3/125, 8.7/125, 9/125, 10/125m single-mode 

UTP Cable limitations

Half Duplex : 1m (up to 100m, subject to fiber length) 
Fiber : 50/125, 62.5/125, 100/140m multi-mode 

Duplex Mode 

Full-or Half-duplex mode 

LED 

Pwr, Fdx, FX Link, FX Act, TX Link, TX Act 

FIber Cable limitations

 100Base-TX/FX(multi-mode) network allows 512-bit time
 delay between any two nodes in a collison domain.  

Connecting to 
(Full/Half-duplex) Cable 
Limitations 

Full-duplex (multi-mode) Node to Hub : 
       2Km Hub to Hub : 2Km 
Full-duplex (single-mode) Node to Hub : 
       20Km Hub to Hub : 20Km 
Half-duplex (multi-mode) Node to Hub : 
       412m Hub to Hub : 412m