Gossen Metrawatt Metrahit Iso Insulation measuring device, CAT III 600 V Metrahit Iso Manual De Usuario
Los códigos de productos
Metrahit Iso
GMC-I Gossen-Metrawatt GmbH
27
Measurements: V/Hz,
Ω, , Temp (°C/°F),
, M
Ω
@UISO
, A/Hz
5.1.1 Direct and Pulsating Voltage Measurement, V DC and V (DC+AC)
➭ Set the CL iP parameter to 0FF in the current clip setup menu.
➭ Set the CL iP parameter to 0FF in the current clip setup menu.
Otherwise all measured values are displayed in amperes,
corrected by the amount resulting from the selected transfor-
mation ratio for an interconnected clip-on current sensor.
corrected by the amount resulting from the selected transfor-
mation ratio for an interconnected clip-on current sensor.
1nFo
Z
...
Z
SET
rAtE
V
...
V
CL IP
1 / 10/100/1000 / 0ff
UV
➭ In accordance with the voltage to be measured, turn the rotary
switch to V
or V .
➭ Connect the measurement cables as shown.
The “
⊥” connector jack should be grounded.
Note
An intermittent acoustic signal warns the operator if the
measured value exceeds the upper range limit in the 1000 V
range.
measured value exceeds the upper range limit in the 1000 V
range.
Make sure that a current measuring range (“A”) has not been
activated when the multimeter is connected for voltage
measurement! If the fuse’s blowing limits are exceeded as a
result of operator error, both the operator and the instrument are
in danger!
activated when the multimeter is connected for voltage
measurement! If the fuse’s blowing limits are exceeded as a
result of operator error, both the operator and the instrument are
in danger!
With the rotary switch in the V position, the multimeter is always in
the 1 V measuring range immediately after it is switched on. As
soon a the MAN / AUTO key is pressed, and assuming the
measured value is less than 280 mV, the multimeter is switched to
the mV measuring range.
the 1 V measuring range immediately after it is switched on. As
soon a the MAN / AUTO key is pressed, and assuming the
measured value is less than 280 mV, the multimeter is switched to
the mV measuring range.
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
COM mA A
V
Temp
Ω MΩ
ISO
– (+)
+ (–)
V= : 100
μV…1000 V
0
20.00
V
DC
AC
TRMS
0
20.00
V
DC
V
V
V
V
> 15 V AC
or > 25 V DC:
> 1000 V:
Warnings regarding dangerous voltage:
Max. 1000 V, 3 kHz
V
: 10 mV
…1000 V
Hz: 1 Hz
… 300 kHz
P
max
= 3 x 10
6
V x Hz
Measuring Ranges:
230
.
0
FUNC
ENTER
MEASURE
SETUP
...
Z
SET
...
V
CL IP
FUNC
ENTER
FUNC
ENTER
UV
0ff
5 ranges: 300 mV, 3 V, 30 V,
300 V and 1000 V