Gossen Metrawatt Metrahit Iso Insulation measuring device, CAT III 600 V Metrahit Iso Manual De Usuario
Los códigos de productos
Metrahit Iso
GMC-I Gossen-Metrawatt GmbH
53
Device and Measuring Parameters
dAtE – enter date
Entering the current date makes it possible to acquire measured
values in real-time.
values in real-time.
1nFo
Z
...
Z
SET
rAtE
V
...
V
dAtE
31.12 (DD: day . MM: month)
Y
ZUV
2005 (YYYY: year)
Y
ZUV
Date and time must be reentered after replacing the batteries.
tiME – set time
Entering the correct time makes it possible to acquire measured
values in real-time.
values in real-time.
1nFo
Z
...
Z
SET
rAtE
V
...
V
t iME
10:24 (hh:mm)
Y
ZUV
Date and time must be reentered after replacing the batteries.
6.5
Default Settings
Previously entered changes can be undone, and the default
settings can be reactivated. This may be advisable under the
following circumstances:
settings can be reactivated. This may be advisable under the
following circumstances:
• after the occurrence of software or hardware errors,
• if you are under the impression that the multimeter does not
work correctly.
➭ Disconnect the device from the measuring circuit.
➭ Remove the batteries temporarily (see also chapter 9.2).
➭ Remove the batteries temporarily (see also chapter 9.2).
➭ Simultaneously press and hold the
and
keys, and connect the battery at the same time.
A sequence of acoustic signals consisting of two immediately
consecutive tones acknowledges successful resetting.
consecutive tones acknowledges successful resetting.
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
ZERO
ESC
ON / OFF
LIGHT