AEG AR 4025 BT 400425 Manual De Usuario
Los códigos de productos
400425
72
ENGLISH
Recycling the packaging conserves raw
materials and reduces waste. Dispose of
any unwanted packaging materials in ac-
cordance with local regulations.
NOTE:
If possible keep the original packaging for the dura-
►
tion of the warranty period of the unit, in order that
you can repack the unit properly in the event of a
warranty claim.
Connection
WARNING:
Damage to property may occur when installing the
unit!
If possible have the unit installed by a qualified
►
specialist.
If you want to install the unit yourself, follow the
►
instructions on connection and installation for safe
and correct operation of the unit.
CAUTION:
Using the wrong connections may damage the unit.
When installing, use the ISO connections on the
►
unit. The vehicle-specific ISO adapter which may be
needed can be obtained from repair shops, specialist
retailers or in the relevant departments of depart-
ment stores.
Connections on the back of the unit
A ISO connection A (power supply)
B ISO connection B (speaker)
C Car fuse (5 A)
D Antenna connection
E Subwoofer connector cable
F Amplifier connector cable (front speaker)
F Amplifier connector cable (rear speaker)
Pinout of ISO connections
ISO connection A
1 not in use
2 Steering wheel control
3 not in use
4 Permanent positive (memory)
5 Control voltage for electronic/
motor antenna or amp
6 not in use
7 12 V (Positive under key)
8 Minus (Ground -)
1 3 5 7
2 4 6 8
ISO connection B
1 3 5 7
2 4 6 8
1 Speaker rear right +
2 Speaker rear right -
3 Speaker front right +
4 Speaker front right -
5 Speaker front left +
6 Speaker front left -
7 Speaker rear left +
8 Speaker rear left -
CAUTION:
Use speakers with an impedance of at least 4 Ohm.
►
The speaker wires must be floating.
►
NOTE:
Always use the cable for the front speakers to
►
connect the unit to two speakers.
Note that connection 4 must be connected to
►
permanent positive for auto preset.
In some car models the default pinout of connec-
►
tions [4] and [7] (ISO A) is swapped in the assembly
plant. If this is the case, auto preset may not func-
tion. To rectify the problem, connections 7 (positive
under key) and 4 (permanent positive) must be
swapped.
Antenna power connection A5 (ISO A)
CAUTION:
Potential damage to unit!
Never connect the antenna power connection to the
►
motor power cable for the antenna.
Max. allowed current: 100 mA.
►
The antenna power connection is available for a relay-
controlled antenna. The relay automatically extends
the antenna when the unit is switched on. The antenna
retracts again when the unit is switched off. This connec-
tion can also be used to control an external amplifier. To
connect this properly please refer to the amplifier
operating manual.