B B Thermotechnik B & B Thermotechnik FF-10V-INT-TE1 Humidity And Temperature Sensor With Transmitter Humidity / Temperature sensor FF-10V-INT-TE1 Hoja De Datos
Los códigos de productos
FF-10V-INT-TE1
DATA SHEET
Technical changes reserved
---------
---------
0141 0316-225 07/2013
Humidity-Temperature probe with
standard signal FF-GLT-Series
Type INT
for duct mounting,
probe installed
Type EXT
with cable,
probe sold
probe sold
Type AF
for wall mounting,
probe sold
Characteristic features
• Standard signal 0 ... 10 V or 4 ... 20 mA
• Linearised and temperature compensated humidity measurement
• High long term stability, innovative technique
• Probe with stainless steel housing 1.4571
• High quality housing enclosure IP 65
• Probe head with PE Sinter filter
• Linearised and temperature compensated humidity measurement
• High long term stability, innovative technique
• Probe with stainless steel housing 1.4571
• High quality housing enclosure IP 65
• Probe head with PE Sinter filter
Areas of application
• Building instrumentation
• Industrial measurement and controlling systems
• Meteorology
• Drying systems
• Industrial measurement and controlling systems
• Meteorology
• Drying systems
Application range
In the area of building instrumentation, there is a requirement for
reasonably priced measuring probes which are suitable for continuous
operation and protected against over voltage and transients. Further
aspects are DC/AC supply, high long term stability as well as a good
measuring accuracy in the application. The B+B humidity probes of
-GLT series are developed for these requirements and are specially
suitable for application in this area due to the modern sensor technolo-
gy and innovative construction with an ASIC.
The measurement of relative humidity is done with a precise and long
term stable capacitive polymer sensor element with industrial rating.
The processing of measured value is linearised and temperature
compensated.For measurement of temperature (optional), a platinum
resistance is used whose values are also converted into a standard
signal. The voltage supply for the 0 ... 10 V model can be done alter-
natively with AC or DC supply. The 4... 20 mA model is meant for only
DC supply.The sensor which is made up of high quality stainless steel
has a fine pored PE protection filter and is made pressure tight (up to
500 mbar) against ambient pressure at the sensor head with a Teflon
tube. Because of this, the probe can also be operated at pressure
difference and higher flow rates, for example in ventilation ducts.
Because of the large connecting area inside the housing and the
documented connecting clamps a fast connection is guaranteed.
Because of the large connecting area inside the housing and the
documented connecting clamps a fast connection is guaranteed.
Description
B+B Thermo-Technik GmbH | Heinrich-Hertz-Straße 4 | D-78166 Donaueschingen
Fon +49 771 83160 | Fax +49 771 831650 | info@bb-sensors.com | bb-sensors.com
1 / 7