Intel D915GEVLK ATX 915G DDR2-533 LGA775 Gigabit LAN BOXD915GEVLK Manual De Usuario
Los códigos de productos
BOXD915GEVLK
Intel Desktop Board D915GEV/D915GRF Technical Product Specification
28
1.8 I/O Controller
The I/O controller provides the following features:
• Two serial ports (Serial Port B is optional)
• One parallel port with Extended Capabilities Port (ECP) and Enhanced Parallel Port
• Two serial ports (Serial Port B is optional)
• One parallel port with Extended Capabilities Port (ECP) and Enhanced Parallel Port
(EPP) support
• Serial IRQ interface compatible with serialized IRQ support for PCI Conventional bus systems
• PS/2-style mouse and keyboard interfaces
• Interface for one 1.44 MB or 2.88 MB diskette drive
• Intelligent power management, including a programmable wake-up event interface
• PCI Conventional bus power management support
• PS/2-style mouse and keyboard interfaces
• Interface for one 1.44 MB or 2.88 MB diskette drive
• Intelligent power management, including a programmable wake-up event interface
• PCI Conventional bus power management support
The BIOS Setup program provides configuration options for the I/O controller.
1.8.1
Serial Ports
The Desktop Board can support up to two serial port connectors. Serial port A is located on the
back panel. Serial port B (optional) is accessible using a connector on the component side of
board. The serial ports support data transfers at speeds up to 115.2 kbits/sec with BIOS support.
back panel. Serial port B (optional) is accessible using a connector on the component side of
board. The serial ports support data transfers at speeds up to 115.2 kbits/sec with BIOS support.
For information about
Refer to
The location of the serial port A connector
Figure 16, page 60
The location of the serial port B connector
Figure 17, page 62
The signal names of the serial port B connector
Table 21, page 64
1.8.2
Parallel Port
The 25-pin D-Sub parallel port connector is located on the back panel. Use the BIOS Setup
program to set the parallel port mode.
program to set the parallel port mode.
For information about
Refer to
The location of the parallel port connector
Figure 16, page 60
1.8.3
Diskette Drive Controller
The I/O controller supports one diskette drive. Use the BIOS Setup program to configure the
diskette drive interface.
diskette drive interface.
For information about
Refer to
The location of the diskette drive connector
Figure 17, page 62
1.8.4
Keyboard and Mouse Interface
PS/2 keyboard and mouse connectors are located on the back panel.
✏
NOTE
The keyboard is supported in the bottom PS/2 connector and the mouse is supported in the top
PS/2 connector. Power to the computer should be turned off before a keyboard or mouse is
connected or disconnected.
PS/2 connector. Power to the computer should be turned off before a keyboard or mouse is
connected or disconnected.