Blade 180 QX HD RTF BLH7400 Hoja De Datos

Change fl ight modes by moving the three-position fl ight mode switch. Ensure 
the fl ight mode switch is in the desired position before fl ying.

• In stability low angle mode (switch position 0), the controls provide a 

minimum bank angle. This mode is shown by the fl ight control board on 
the quadcopter glowing solid blue.

• In stability high angle mode (switch position 1), the controls provide for a 

maximum bank angle. This mode is shown by the fl ight control board on 
the quadcopter slowly fl ashing blue.

• Agility mode (switch position 2) is shown by the fl ight control board on 

the quadcopter glowing solid red.

When powered on, this transmitter is automatically in high-rate mode. 
Change rates by pressing and releasing the right control stick.

• In low-rate mode, the controls cannot reach their maximum values.
• In high-rate mode, the controls can reach their maximum values.

If you purchased a BNF 180 QX HD, the channel 5 switch on your transmitter will select fl ight modes. When the LED on 
the control board is solid blue, the fl ight mode is set to stability low angle mode. When the LED is slowly blinking blue, 
the quadcopter is in stability high angle mode. When the light is solid red, the quadcopter is in agility mode. See the 
Transmitter Setup Table for specifi c setup information.