STMicroelectronics Discovery kit for STM32L151/152 line - with STM32L152RC MCU STM32L152C-DISCO STM32L152C-DISCO Hoja De Datos
Los códigos de productos
STM32L152C-DISCO
Electrical characteristics
STM32L15xCC STM32L15xRC STM32L15xUC STM32L15xVC
DocID022799 Rev 6
6 Electrical
characteristics
6.1 Parameter
conditions
Unless otherwise specified, all voltages are referenced to V
SS
.
6.1.1
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100% of the devices with an ambient temperature at T
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100% of the devices with an ambient temperature at T
A
= 25 °C and T
A
= T
A
max (given by
the selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on
characterization, the minimum and maximum values refer to sample tests and represent the
mean value plus or minus three times the standard deviation (mean±3?).
are indicated in the table footnotes and are not tested in production. Based on
characterization, the minimum and maximum values refer to sample tests and represent the
mean value plus or minus three times the standard deviation (mean±3?).
6.1.2 Typical
values
Unless otherwise specified, typical data are based on T
A
= 25 °C, V
DD
= 3.6 V (for the
1.65 V
V
DD
3.6 V voltage range). They are given only as design guidelines and are not
tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated
(mean±2?)
.
6.1.3 Typical
curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
not tested.
6.1.4 Loading
capacitor
The loading conditions used for pin parameter measurement are shown in
6.1.5
Pin input voltage
The input voltage measurement on a pin of the device is described in
Figure 10. Pin loading conditions
Figure 11. Pin input voltage
ai17851b
C = 50 pF
STM32L1xx pin
ai17852b
STM32L1xx pin
V
IN