Reely remote control RtF 2100 mm 1289571 Hoja De Datos

The model airplane must be set by proper placement of the flight battery (and, if required, by addition of trimming lead)

so that the centre of gravity is approx. 65 mm behind the nose strip of the wing. 
To do so, mark the corresponding centre of gravity position at the bottom of the wing with a pen. From the bottom, hold 

the assembled and ready-to-fly model at the measured positions with your index fingers (or a corresponding device).
If the centre of gravity is set correctly, the model airplane should be leaning slightly forward.

 

Always measure the centre of gravity with the cabin hood in place.

For the first flights, set the centre of gravity at approx. 62 mm wing depth instead of at 65 mm. The best

centre of gravity then can be reset slowly.

Before starting your model for the first time, you need to familiarise yourself with the remote control, the control func-

tions and test the model functions. The functions and commissioning of the remote control system can be taken in the 

operating instructions separately enclosed with the remote control. 
Always turn on the transmitter first and put the speed control lever to „Motor off“.
Connect the flight battery to the flight controller (see figure 7, item 7). The flight controller now checks the „Motor off“

control signal of the transmitter. Depending on how the motor brake is programmed, the flight controller‘s readiness

for operation is signalled by one or two sounds.