Blade 200 SR X RTF BLH2000 Hoja De Datos

ON

1 2 3 4 5 6 7 8 9 10

Power LED

Power LED

Change fl ight modes by moving the three-position fl ight 
mode switch. Ensure the fl ight mode switch is in the desired 
position before fl ying.

• In Beginner Mode (switch position 0), the bank angle is 

limited to 15 degrees. When the cyclic stick is released, 
the model will return to level.

• In Intermediate Mode (switch position 1), the bank angle 

is limited to 35 degrees. When the cyclic stick is released, 
the model will return to level.

• In Experienced Mode (switch position 2), the bank angle 

is not limited. When the sticks are released, the model will 
not return to level. If you lose orientation, use the Panic 
Switch to return the model to a familiar orientation.

Change rates by moving the two-position dual rate switch.

• Low rate reduces the control rates, providing an easier to 

fl y model. Beginners should use low rate for initial fl ights.

• High rate provides full control and should be used by 

intermediate and experience pilots.

Refer to the Transmitter Setup Table for which switch on your transmitter selects fl ight modes and specifi c setup information.