Conrad 16-Channel Running Light Controller Module 190486 Hoja De Datos

Figure 3

“RC” Mode:
If the 16-channel running light control is to be used for model construction and operated by
remote control, a free receiver output assigned to a rocker switch with central position or a
rotary/sliding control in the transmitter can be used for control.



Practical advice:
For simple switching during the flight or drive, the best switch turned out to be a
rocker switch with central position (on/off//on).

The impulse line of the respective receiver output must be connected to the “RC” input. The
minus line of the receiver output is connected to the ground contact “GND”.

“Stand alone” Mode:
If the 16-channel running light control is not to be operated via a remote control, the “RC” input
must be connected to the earth connection “GND”. In this case, the four switching outputs (S1
to S4) cannot be used.