TP-LINK 24-Port 10/100Mbps + 4-Port Gigabit L2 Managed Switch TL-SL3428 Hoja De Datos

 

37

 

Etherchannel Commands are used to configure LAG and LACP function.   

LAG (Link Aggregation Group) is to combine a number of ports together to make a single 

high-bandwidth data path, which can highly extend the bandwidth. The bandwidth of the LAG is 

the sum of bandwidth of its member port.   

LACP (Link Aggregation Control Protocol) is defined in IEEE802.3ad and enables the dynamic link 

aggregation and disaggregation by exchanging LACP packets with its partner. The switch can 

dynamically group similarly configured ports into a single logical link, which will highly extend the 

bandwidth and flexibly balance the load. 

The channel-group command is used to add a port to the EtherChannel Group 

and configure its mode. To delete the port from the EtherChannel Group, please 

use no channel-group command. 

channel-group num mode { on | active | passive } 

no channel-group 

num  ——  The number of the EtherChannel Group, ranging from 1 to 14. 

on  ——  Enable the static LAG. 

active  ——  Enable the active LACP mode. 

passive  ——  Enable the passive LACP mode. 

Interface Configuration Mode (interface fastEthernet / interface range 

fastEthernet / interface gigabitEthernet / interface range gigabitEhternet) 

Add the Fast Ethernet port 2-4 to EtherChannel Group 1 and enable the static 

LAG: 

TL-SL3428(config)#interface range fastEthernet 1/0/2-4 

TL-SL3428(config-if-range)#channel-group 1 mode on