TP-LINK 24-Port 10/100Mbps + 4-Port Gigabit L2 Managed Switch TL-SL3428 Hoja De Datos

 

On 

A device is linked to the corresponding port, but no activity. 

Flashing 

Data is being transmitted or received. 

Green 

The linked device is running at 1000Mbps. 

Yellow 

The linked device is running at 10/100Mbps. 

1000Mbps 

Off 

No device is connected to the corresponding port. 

1.  TL-SL3428 features some “Combo” ports. A “Combo” port consists of a RJ45 port and an SFP 

port, and the two ports share the same LED. 

2.  For TL-SL3428, When using the SFP port with a 100M module or a gigabit module, you need 

to log on to the GUI (Graphical User Interface) of the switch and configure its corresponding 
Speed and Duplex mode on Switching→Port→Port Config page. For 100M module, please 
select 100MFD while select 1000MFD for gigabit module. By default, the Speed and Duplex 
mode of SFP port is 1000MFD. 

3.  For TL-SL3452, the SFP port can be only used with a gigabit module.   

 

The rear panel of TL-SL3428/TL-SL3452 features a power socket and a Grounding Terminal 

(marked with ). 

 

Figure 2-3 Rear Panel of TL-SL3428 

 

Figure 2-4 Rear Panel of TL-SL3452 



  Grounding Terminal: TL-SL3428/TL-SL3452 already comes with Lightning Protection 

Mechanism. You can also ground the switch through the PE (Protecting Earth) cable of AC cord 

or with Ground Cable. For detail information, please refer to Installation Guide. 



  AC Power Socket: Connect the female connector of the power cord here, and the male 

connector to the AC power outlet. Please make sure the voltage of the power supply meets the 

requirement of the input voltage (100-240V~ 50/60Hz 0.6A). 

8