Reely Hendheld RC 2.4 GHz No. of channels: 4 1310036 Manual De Usuario
Los códigos de productos
1310036
19
18. Switching the Digital Code
The remote control transmitter enables you to control receivers with the digital code „AFHDS“ and „AFHDS2A“. Ex
works, the transmitter is set to the enclosed „AFHDS2A“-encoded receiver.
If you want to operate a REELY receiver with the digital code „AFHDS“, the transmitter must be switched first and then
If you want to operate a REELY receiver with the digital code „AFHDS“, the transmitter must be switched first and then
the receiver must be bound to the transmitter (see following chapter).
To switch the digital code at the transmitter, proceed as follows:
• Switch off the transmitter.
• Move the two control levers to the lower left corner and keep it
To switch the digital code at the transmitter, proceed as follows:
• Switch off the transmitter.
• Move the two control levers to the lower left corner and keep it
there.
• Switch on the transmitter with the on/off switch with the control
levers deflected.
• Release the two control levers so that they move to the centre
position.
• If the LED display flashes, the transmitter has switched to
the digital code „AFHDS“. If the LED display flashes and the
remote control also issues short signal sounds in a cycle of
one second, the transmitter has switched to the digital code
„AFHDS2A“.
• Switch off the transmitter so that the currently set digital enco-
ding is saved.
Important!
The receiver enclosed with the remote control system „HT-4“ works with code „AFHDS2A“. Therefore, al-
ways observe that the right code is programmed at the transmitter!
Figure 14