Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Hoja De Datos

● Select the function name

and return to the Model

menu  by  touching  the 

R T N   b u t t o n . 　 O r   t h e 

H O M E / E X I T   b u t t o n   i s

pushed.

This function corrects slowing of engine speed 

caused by swash plate operation during aileron 

or elevator operation. The method of applying 

clockwise or counterclockwise torque when 

pirouetting can also be corrected.

● AIL to THR mixing counteracts the lag in

engine RPM's when an aileron input is given

to the helicopter. Engine over-speeding

can  be  adjusted  independently  for  the

right aileron and left aileron inputs utilizing

Rates 1 and 2.

●  Select  [THROTTLE  MIX]  at  the  Model

menu and access the setup screen

shown  below  by  touching  the  RTN

button.

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

(Currently selected condition name)

 When using this function, move the cursor to

the [ACT] item and touch the RTN button to

switch to the data input mode.

 Select the ACT mode by scrolling the touch

sensor.

*The display blinks.

 Touch the RTN button to activate the mixing

and  return  to  the  cursor  mode.  (ON  is

displayed.)

 [Switch selection]
 When [ [--]] is set, the swash mixing function

is always active and operated by merely

selecting the condition.

 When setting an [ON]/[OFF] switch, move the

cursor to the [SW] item and touch the RTN

button to call the selection screen. Set the

switch and its ON position.

*For a description of the switch selection method, see the 

description at the back of this manual.

 Move the cursor to the mixing rate item you

want to correct and touch the RTN button

to switch to the data input mode. Adjust the

rate independently by scrolling the touch

sensor.

 Initial value: 0%
 Adjustment range: -100~+100%

*When the RTN button is touched for one second, the rate is 

reset to the initial value.)

 Touch the RTN button to end the adjustment

and return to the cursor mode.

 Move the cursor to the [MODE] item and

touch the RTN button to switch to the data

input mode.

 Select the operation mode by scrolling the

touch sensor.

*The display blinks.

 CTRM mode: Corrects near the center only.
 LIN. mode: Corrects the complete range.
 Touch  the  RTN  button  to  change  the

operation mode and return  to the cursor

mode.

●Condition selection