Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Hoja De Datos

Los códigos de productos

1-F8075

<Functions of System Menu>

● Select the function name

and return to the System

menu by touching the

R T N b u t t o n . 　 O r t h e

H O M E / E X I T b u t t o n i s

pushed.

<SensorTouch™>

RETURN

Operation direction reversal method

1. Select [H/W REVERSE] and access the setup

screen shown below by touching the RTN

button.

2. Move the cursor to the item corresponding

to the H/W (hardware) you want to reverse

and touch the RTN button to switch to the

data input mode.

3. Select the mode by scrolling the touch

sensor. The display blinks. When the RTN

button is touched, the operation direction is

reversed. (To terminate the mode change,

touch the S1 button.)

"NORM": Normal operation direction
"REV" : Operation direction is reversed.

H/W SETTING

Hardware reverse and stick mode

H/W reverse

This function reverses the operation direction of

the sticks, switches, trimmer levers, and knobs.

Note: This setting reverses the actual operation

signal, but does not change the display

indicators. Use the Normal mode as long as

there is no special reason to use the Reverse

mode.

Stick mode

This function changes the stick mode of

transmitter.

Note: This will not change the throttle ratchet,

etc. Those are mechanical changes that

must be performed by a Futaba service

center.

Note: After changing the mode, these changes

are only applied to new models. It is not

applied to an existing model.

Stick calibration

J1-J4 stick correction can be performed.

● Select [H/W SET] at the system menu and access

the setup screen shown below by touching the

RTN button.

Changing stick mode

1.Select [STICK MODE] and access the setup

screen shown below by touching the RTN

button.

2. Move the cursor to the "STICK MODE" item

and touch the RTN button to switch to the

data input mode.

3. Select the mode. The display blinks. When

the RTN button is touched, the stick mode is

changed. (To terminate the mode change,

touch the S1 button.)

(J1)

(J2)

(J4)

(J3)

Mode

Aileron

Throttle

Elevator

Rudder

Aileron

Elevator

Throttle

Rudder

Throttle

Elevator

Aileron

Rudder

Elevator

Throttle

Aileron

●Access setup screen

Scrolling

● Moving cursor