Creative Wireless Adapter CB3200 Manual De Usuario
27
Bluetooth icon in the Notification area, at the far right of the taskbar when an incoming call is
detected. Click the balloon to acknowledge the notification, and then, in the Incoming Call
dialog box, click the Accept button to accept the call.
The audio signal from the phone is re-routed to the audio output device (speakers or
earphones) on the computer, and the microphone on the computer provides the audio input
for the phone. To reject the incoming call, when the Incoming Call dialog box is displayed,
click the Reject button.
detected. Click the balloon to acknowledge the notification, and then, in the Incoming Call
dialog box, click the Accept button to accept the call.
The audio signal from the phone is re-routed to the audio output device (speakers or
earphones) on the computer, and the microphone on the computer provides the audio input
for the phone. To reject the incoming call, when the Incoming Call dialog box is displayed,
click the Reject button.
Network Access
The Bluetooth Network Access service enables a remote Bluetooth device to access a Local
Area Network that is physically attached to this computer or allows a remote device to
become part of an ad hoc network provided by this computer.
After this computer has been configured to provide the Network Access service to other
Bluetooth devices, it will not be able to use the Bluetooth Network Access service provided by
another Bluetooth device without being re-configured. In other words, this computer cannot be
both a Bluetooth Network Access server and a Bluetooth Network Access client at the same
time.
Setup for Windows 98SE & Windows Me
Note: Internet Protocol routing software is required on Windows 98SE and Windows Me
servers. Install and configure the routing software as instructed by the software's
manufacturer before you configure the computer as a Network Access server.
Configure the server:
Area Network that is physically attached to this computer or allows a remote device to
become part of an ad hoc network provided by this computer.
After this computer has been configured to provide the Network Access service to other
Bluetooth devices, it will not be able to use the Bluetooth Network Access service provided by
another Bluetooth device without being re-configured. In other words, this computer cannot be
both a Bluetooth Network Access server and a Bluetooth Network Access client at the same
time.
Setup for Windows 98SE & Windows Me
Note: Internet Protocol routing software is required on Windows 98SE and Windows Me
servers. Install and configure the routing software as instructed by the software's
manufacturer before you configure the computer as a Network Access server.
Configure the server:
1. From Windows Control Panel, double-click the Network icon.
2. On the Configuration tab, select TCP/IP-> Bluetooth LAN Access Server
Driver (scroll down if necessary).
3. Click
Properties and select the IP Address tab.
Select Specify an IP address
Enter an IP Address (suggested value - 192.168.1.1)
Enter a Subnet Mask (suggested value - 255.255.255.0)
Enter an IP Address (suggested value - 192.168.1.1)
Enter a Subnet Mask (suggested value - 255.255.255.0)
4. Click
OK to close each dialog box, and then click Yes to restart the computer.
Setup for Windows 2000 and Windows XP
If Internet Connection sharing was previously enabled (before Creative Bluetooth Software
was installed) it must be disabled and then re-enabled before the Bluetooth network adapter
can use it.
Configure for Internet/LAN:
Before you begin, verify that the:
If Internet Connection sharing was previously enabled (before Creative Bluetooth Software
was installed) it must be disabled and then re-enabled before the Bluetooth network adapter
can use it.
Configure for Internet/LAN:
Before you begin, verify that the:
Bluetooth software is installed and enabled
Bluetooth device is turned on
Server has access to the Local Area Network (LAN). If the
Bluetooth device is turned on
Server has access to the Local Area Network (LAN). If the
LAN provides Internet access, the connection can be
verified by using the server’s browser to connect to the
Internet through the LAN.
verified by using the server’s browser to connect to the
Internet through the LAN.
1. Configure Bluetooth - right-click the Bluetooth icon in the notification area,
select Advanced Configuration, and then