Whirlpool WWDC 6400 Manual De Instrucciónes

The washing machine is fitted with a transport bracket to

avoid any possible damage during transport.
IMPORTANT: Before using the washing machine, the

transport bracket at the back MUST be removed.
1.  Unscrew the two screws “A” and the four screws “B”

   with a flat screwdriver or a No. 8 hex nut box spanner.
2.  Remove the transport bracket.
3.  Replace the four outer screws “B” on the machine and

  tighten them.
4.  Clip the two seals “C” supplied into the openings “D” 

  of the washing machine.
Note: do not forget to replace and tighten the four 

GB 3

Install the washing machine on a level surface, near to

electrical, water and drain connections.
If the floor is uneven, adjust the feet (do not insert pieces 

of wood, cardboard etc. under the feet):
1.  Loosen the locknut using the wrench provided.
2.  Adjust the height of the feet by hand.
3.  Retighten the locknut by turning it anti-clockwise.
Make sure that the feet are resting correctly on the

and stable (use a spirit level).
The washing machine can be installed in an area 40 cm wide

and 63 cm deep.
Note: if you install the machine on thick carpet, adjust the

feet to ensure that there is sufficient space under the

machine for the air to circulate.