Bunn Hot Beverage Maker TB3Q Manual De Usuario

Page 3

#00831.0000

#00656.0001

#03408.0000

#03409.0000

#37881.0000

• FILL WATER TANK

BEFORE ENERGIZING

• DO NOT OVERLOAD

CIRCUIT

• KEEP AWAY FROM

COMBUSTIBLES

• DO NOT DEFORM

PLUG OR CORD

• FAILURE TO COMPLY

RISKS EQUIPMENT

DAMAGE, FIRE OR

SHOCK

• BREWER ENERGIZED

UNLESS UNPLUGGED

SEE

INSTRUCTIONS

WARNING

#06064.0000

INTRODUCTION

This equipment will brew a three-gallon batch of fresh tea into an awaiting dispenser. The tea will be dispensed

at approximately room temperature. The brewer is only for indoor use on a sturdy counter or shelf.

CONTENTS

Warranty ...................................................................2

Introduction ..............................................................3

User Notices .............................................................3

Electrical Requirements ...........................................4

Plumbing Requirements ..........................................5

Initial Set-Up (TB3Q) .................................................6

Initial Set-Up (TB3) ...................................................7

Auto Sweetener Set-up .............................................8

Adjusting Brew Volumes ...........................................9

Operating Controls ..................................................10

Tea Brewing ............................................................10

Cleaning ..................................................................11

USER NOTICES

Carefully read and follow all notices on the equipment and in this manual. They were written for your protection.

All notices on the equipment should be kept in good condition. Replace any unreadable or damaged labels.

Make su

re Funnel i

s rotated and align

ed with Make sure Funnel is rotated and alig

ned with

Tea Disp

enser on th

e RIGHT side to avo

id Tea Dispenser on the LEFT side to

avoid

potentia

l burns and

water spills. RIGH

T potential burns and water spills.

LEFT

WARNING

HOT LIQUIDS

#41995.0000

To reduce the risk of electric shock,

do not remove or open cover.

No user-serviceable parts inside.

Authorized service personnel only.

Disconnect power before servicing.

WARNING

Fill water tank before turning - on -

thermostat or connecting appliance

to power source.

Use only on a properly protected

circuit capable of the rated load.

Electrically ground the chassis.

Follow national/local electrical codes.

Do not use near combustibles.

FAILURE TO COMPLY RISKS EQUIPMENT

DAMAGE, FIRE, OR SHOCK HAZARD

READ THE ENTIRE OPERATING MANUAL

BEFORE BUYING OR USING THIS PRODUCT

THIS APPLIANCE IS HEATED WHENEVER

CONNECTED TO A POWER SOURCE

As directed in the International Plumbing Code of the

International Code Council and the Food Code

Manual of the Food and Drug Administration (FDA),

this equipment must be installed with adequate

backflow prevention to comply with federal, state

and local codes. For models installed outside the

U.S.A., you must comply with the applicable Plumb-

ing /Sanitation Code for your area.

41465.1 011711

#00658.0000