Whirlpool WET3300XQ Guía De Instalación Rápida

Do not cut yellow strap. Pull yellow strap firmly, until completely 

removed from washer/dryer. There should be 2 cotter pins on 

the end of the shipping strap. Remove the hang tag and pin 

from the vent pipe.

Tilt the washer/dryer forward. Move each of the 2 rear legs in 

an up-down motion to check the self-adjusting leveling legs 

for free movement. This is required for proper leveling. Gently 

lower the washer/dryer to the floor.

To avoid floor damage, set washer/dryer onto cardboard before 

moving across floor. Move washer/dryer close to its final location.

Cut the shipping strap about 16" (406 mm) from the plug end. 

Look for the words “CUT HERE.” Discard end with cotter pins. 

You will use the remaining piece of shipping strap to secure 

the drain hose.

CUT 

HE

RE

Prop up the front of the washer/dryer  

about 4" (102 mm) with a wood block  

or similar object that will support the  

weight of the washer/dryer. Then screw the locknut onto each 

foot to within 1" (25 mm) of the foot base.

Screw the feet into the threaded holes at  

the front corners of the washer/dryer until  

the jam nuts touch the washer.
NOTE: Do not tighten the nuts until the washer/dryer is level.
Tilt the washer/dryer back and remove the wood block. Gently 

lower the washer/dryer to the floor.