Berkel FMS40 Manual De Usuario
– 4 –
FMS30 & FMS40 Owner/Operator Manual
ELECTRICAL CONNECTIONS
ELECTRICAL CONNECTIONS (CORD CONNECTED MIXERS)
Single-Phase Mixer
The electrical cord on this machine is equipped with a three-pronged grounding
plug which must be connected to a properly grounded receptacle. If the receptacle is not the
proper grounding type, contact an electrician. Do not remove the grounding prong from the
plug.
proper grounding type, contact an electrician. Do not remove the grounding prong from the
plug.
ELECTRICAL CONNECTIONS (NON-CORD CONNECTED MIXERS)
Electrical and grounding connections must comply with the applicable portion of
the National Electrical Code and/or other Local Electrical Codes.
Disconnect the electrical power to the machine and follow lockout / tagout
procedures.
Three-Phase Mixer
A hole for the 3/4 "-trade-size conduit is located in the rear of the pedestal. Make electrical connections
per the wiring diagram located on the inside of the top cover.
per the wiring diagram located on the inside of the top cover.
• Remove side cover.
• Connect
fi eld supply lead wires L1, L2, and L3 to supply harness wires labeled "SERVL1",
"SERVL2", and "SERVL3" respectively.
• Connect ground wire to supply harness green wire.
• Reinstall side cover.