Whirlpool WFW9151YW Manual De Usuario

Promptly remove garments after cycle has 

completed to avoid odor and rusting of  

metal objects on garments. When unloading 

garments, pull back the door seal and check  

for small items between the tub and the basket.
If you will be unable to remove the load promptly, use  

the TumbleFresh

™

 option to automatically tumble the load  

periodically for up to 6 hours. 
NOTE:

n

  

After any wash cycle is completed, the door must be  

opened and then closed before a new cycle can begin.

n

  

A small amount of water may remain in the dispensers  

after the wash cycle is complete. This is normal.

n

 

This washer has a tight seal to avoid water leaks. To  

avoid odors, leave the door open to allow the washer  

to dry between uses. 

Keep your washer as clean and fresh as your clothes.  

To keep washer interior odor-free, follow this recommended 

cleaning procedure at least once a month:
1.  Make sure laundry drum is empty.
2.  Using recommended AFFRESH

®

 washer cleaner, add 

one tablet to washer basket.

 OR
  If using liquid chlorine bleach, add 2/3 cup (160 mL) to 

liquid chlorine bleach dispenser.

IMPORTANT: Do not add detergent to Clean Washer 

with Affresh

®

 cycle. Do not use more than recommended 

amount of bleach to avoid damaging product over time.
3.  Close washer door and dispenser drawer.
4.  Press POWER.
5.  Select CLEAN WASHER with AFFRESH

®

 cycle.

6.  Press and hold START/PAUSE. 
NOTE: The basket will rotate, then the door will unlock, 

lock again, and then the cycle will continue. The washer will 

not fill, and the basket will rotate while the washer runs a 

short sensing cycle. This will take approximately 3 minutes. 
7.  The cycle will determine whether clothing or other items 

are in the washer. If no items are detected in the washer, 

it will proceed to Step 8. 

  If the Wash LED light flashes, the door will unlock. 

Remove clothing or items in the washer. Press POWER 

to cancel the flashing LED light. Then repeat steps 1, 2, 

and 6 to start the cycle again. 

8.  Once the cycle has started, allow it to finish. If START/

PAUSE or POWER is pressed before the cycle is 

complete, “Int” (Interrupted) will appear in the display.  

It may take up to 10 minutes for the door to unlock.

9.  After the cycle has ended, leave the door open slightly, 

to allow for better ventilation and drying of washer 

interior. 

To clean exterior:
1.  Use a soft, damp cloth or sponge to wipe up any spills.
2.  Use mild soap and water if needed. 
IMPORTANT: To avoid damaging washer finish, do not use 

abrasive products.