Solo USA MISTBLOWER 450 Manual De Usuario

 

Maintenance and Care 

 

ENGLISH

  9 

 

The correct spark plug with thermal range 200 is 
available under the following brands: 

BOSCH                                          WSR6F 

CHAMPION     RCJ-6Y or similar 

The correct electrode gap is 0.5 mm. 

Check the plug after every 50 operating hours 
and replace if electrodes are worn. 

 

Store the motorized mistblower in a dry room. Cover 
the unit and keep inaccessible to children.   
Treatment with special anti-corrosion oil is not required 
if the mistblower is normally used with SOLO 2T Oil 
two-cycle oil in the fuel mixture. 
For extended storage, completely empty the fuel tank. 
 

 

The carburettor has been adjusted optimally at the 
factory. Subject to the operational altitude (mountains 
or low lying areas), the carburettor may require 
readjustment.  

 

 

 

 

 
 
 

 

 

 

 

 

 

 

 
 
 

 

 

 
 
 
 

The carburettor has 3 adjusting screws: 

•  Idling end-stop screw "T"  
•  Low speed mixture screw "L" 
•  High speed mixture screw "H" 

 Only qualified mechanics must adjust the 
regulating screws for idle mixture "L" and full 

load mixture "H". 

Turn the idling end-stop screw "T" to adjust the idling 
speed in accordance with the details provided in the 
specification. Use an engine rev counter for this job. 
•  If the idling speed is too high, turn the idling end-

stop screw "T" anti-clockwise. 

•  If the idling speed is too low (engine stops) turn the 

idling end-stop screw "T" clockwise until the engine 
runs smoothly. 

If the idling speed cannot be set correctly with the idling 
end-stop screw "T", request an authorised service 
centre to tune the carburettor. 

The following instructions are for authorised 
service shops 
Information about the standard settings can be 
requested from the specialist workshop of our customer 
service department or downloaded from our Internet 
portal for specialist dealers at www.part-and-more.org. 

D-CUT carburettors: 
Use the D-CUT carburettor key to adjust the idle 
mixture screw "L" and the full load mixture screw "H". 
Carburettors with limiter caps: 
The regulating screws for idle mixture and full load 
mixture can only be adjusted in a limited range. 
Clean the air filter before adjusting the low speed 
screw! 
Let the engine run warm before adjusting the engine 
speed. 

The carburettor is tuned for optimum engine 
performance. Use a rev counter to tune the 

carburettor correctly!  
Do not adjust the engine to a higher speed. Excessive 
engine speed can lead to major engine damage!