Siemens SIMATIC NET CP 343-1 Manual De Usuario

B3L−7

CP 343-1 Lean for Industrial Ethernet / Manual Part B3L

Release 03/2007
C79000-G8976-C198-04

It is possible to download the configuration data to the CP over MPI or
LAN/Industrial Ethernet. You require STEP 7 with NCM S7 for Industrial Ethernet
(NCM IE) with the following version:

Table 1-1

 

V5.2 or higher

The range of functions of the CP 343−1 Lean (CX00) can be

configured.

V5.4 or higher

Requirement for configuring the full functionality of the

CP 343−1 Lean (CX10 with firmware V1.0) including PROFINET

IO.

V5.4 Service Pack 2 *)

Requirement for configuring the full functionality of the

CP 343−1 Lean (CX10 with firmware V2.0) including Web

diagnostics.

*) To use the CP with V5.4 Service Pack 1, you will need to install Hotfix 2, the corresponding hardware

update and a block setup. You will find more information at the following Internet page:

For some communications services, there are pre-programmed blocks (FCs/FBs)
available as the interface in your STEP 7 user program.

You will find a detailed description of these blocks in the NCM S7 for Ethernet
manuals.

Notice
We recommend that you always use the latest block versions for all module types.
You will find information on the latest block version and links to download the

current blocks in our Customer Support area on the Internet:

If you are using older block types, this recommendation only applies if you also

have the latest firmware version.

You will find further information and Internet addresses in the Preface of the
General Part of this manual.