Graco 332230EN-F Manual De Usuario

NOTE: Glass bead system and paint guns can be 
mounted on either side of sprayer. 

1. Turn off unit. Relieve pressure in paint striper and 

remove hopper. 

2. Locate belt shroud. Loosen knob (AA) and rotate 

shroud (BB). 

3. With belt guard off, install mounting plate coupler 

(CC) onto pulley (DD) with two shoulder screws 
(EE) and serrated nuts. Position slot on back of 
pulley up and move serrated nut with finger to 
accept shoulder bolt threads. Tighten shoulder bolt 
by hand until the teeth on the serrated nut catch the 
aluminum on the fan. Torque to 16 to 18 ft-lb 
(21 to 24 N•m).

4. Use star bit (supplied) to remove four screws from 

shroud. Remove original fan grill. 

5. Use existing hardware to install new open-centered 

fan grill (FF). Do not over-tighten. Make sure fan 
protrudes out, not into the unit. Discard or store old 
close-centered fan grill. 

6. Close belt shroud (BB) with new fan grill onto unit. 

NOTE: You may need to flex shroud around 
extended shaft on the fan pulley. 

ti20715a

AA

BB

ti20525a

DD

CC

EE

ti20713a

FF

ti20519a

Shroud

Shroud

FF

FF

ti20714a

ti21196a

BB