GenTran POWER STAY 6370C Prospecto

STEP 5
Insert short Parallel Cables into “Parallel Operation”
jacks on the first generator.  Do not be concerned with 
polarity when connecting to these outlets, as the 
polarity is handled by the internal computer chip within 
the EU3000i.  Then attach the first green/yellow ground 
cable to grounding stud on the lower right side of the 
first generator using a screwdriver.

GROUND

STEP 6
Insert the set of longer Parallel Cables into “Parallel Operation” jacks 
on second generator. Attach green/yellow ground cable to grounding 
stud on the lower right side of the second generator as well.

During operation, if the Parallel Power Kit is not feeding power to 
your load when generators are running, it is possible that the circuit 
breaker has been tripped.  You will need to reset circuit breaker on 
the front of the Parallel Power Kit to “ON”.  

Be sure to shut down generators before connecting to or 
disconnecting from Parallel Power Kit.

For 120 volt applications ONLY.

NOTE:   To use your paralleled 
generators to provide backup 
power to a home or other 
dwelling, or an RV, you will need 
an adapter cord to run from the 
Parallel Power Kit (use 10/3 or 
10/4 cord) with an appropriate 
female connector to plug into your 
power inlet box, transfer switch or 
RV.  A transfer switch is required 
by the National Electrical Code 
Article 702.6 for all backup 
generator installations.

P.O. Box 1001, Alpharetta, GA  30009

Toll Free:  1-888-GEN-TRAN

www.gen-tran.com

PN 511759 Rev A

WARNING:  Hazardous voltages present when generators running.  Will cause death, serious injury or substantial property damage. Shut 
off generators before connecting to or disconnecting from Parallel kit. IMPORTANT:  The accessories noted here are intended for 120 volt 
use only.  Transfer switches and power inlet boxes should be installed by a qualified professional familiar with residential wiring and 
electrical codes.  Gen/Tran accepts no responsibility for accidents caused by incorrect or in appropriate installation or use of this product. 

GenTran Model 

300660

or

301060

GenTran 05302

Or

GenTran 14302

GenTran Part 

RJBP6361

Honda Code 

6363550

** Use 10/4 or 

10/3 Cord **

GenTran Part 

RJBC530

or

RJBC1430

Depending on transfer 

switch or power inlet 

box model

CIRCUIT BREAKER

DO YOU NEED A TRANSFER SWITCH 

OR OTHER ACCESSORIES?