Craftsman 12" Drill Press with Laser and LED Light Manual De Propietario

Carefully unpack the Drill Press and all its parts, and compare against the 

illustration following. 

•  To avoid injury from unexpected starting, do not plug the power cord into a  

   power source receptacle during unpacking and assembly. This cord must  

   remain unplugged whenever you are assembling or adjusting the drill press.

•  If any part is missing or damaged, do not plug the drill press in until the miss-  

   ing or damaged part is replaced, and assembly is complete.

•  To protect the drill press from moisture, a protective coating has been applied  

   to the machined surfaces.

   Remove this coating with a soft cloth moistened with kerosene .

WARNING: To avoid fire or toxic reaction, never use gasoline, naphtha, acetone, 

lacquer thinner or similar highly volatile solvents to clean the drill press.

Unpack carton; check the machine to see parts listed below:

A.   Main parts :   

See Fig. 1 

      1. Head assembly   

                                               

      2. Column Assembly                                           

      3. Table                         

                  

      4. Base                                      

      

5. ON/OFF Switch

       

6. Flexible Lamp            

       
      

To turn on drill press, lift paddle switch from bottom.

     To turn off drill press, push paddle switch down. 

      To prevent unauthorized use, remove the center key from the 

      switch. 

      Drill press cannot be turned 

ON if key is not inserted.