Craftsman 15" Drill Press with Laser and LED Light Manual De Propietario

WARNING: Improper connection of equipment grounding conductor 

can result in the risk of electrical shock. Equipment should be grounded 

while in use to protect operator from electrical shock.

-   Check with a qualified electrician if you do not understand grounding 

    instructions or if you are in doubt as to whether the tool is properly  

    grounded.

-   This tool is equipped with an approved cord and a 3-prong grounding  

    type plug for your protection against shock hazards.

-   Grounding plug should be plugged directly into a properly installed  

    and grounded 3-prong grounding-type receptacle, as shown.

-   Do not remove or alter grounding pin in any manner. In the event  

    of a malfunction or breakdown, grounding provides a path of least 

    resistance for electrical shock.

WARNING: This Drill Press is for indoor use only. Do not expose to rain  

    or use in damp locations. 

USE PROPER EXTENSION CORD. Make sure your extension cord is 

in good condition. When using an extension cord, be sure to use one 

heavy enough to carry the current your product will draw. An undersized 

cord will cause a drop in line voltage, resulting in loss of power and 

cause overheating.

Be sure your extension cord is properly wired and in good condition. Al-

ways replace a damaged extension cord or have it repaired by a quali-

fied person before using it. Protect your extension cords from sharp 

objects, excessive heat and damp or wet areas.

WARNING: To avoid electrical hazards, fire hazards, or damage to the 

tool, use proper circuit protection. Use a separate electrical circuit for 

your tools. To avoid shock or fire, if power cord is worn or cut, or dam-

aged in any way, have it replaced immediately.

WARNING: This tool must be grounded while in use to protect the op-

erator from electrical shock.

IN THE EVENT OF A MALFUNCTION OR BREAKDOWN, grounding 

provides a path of least resistance for electric current and reduces the 

risk of electric shock. This tool is equipped with an electric power cord 

that contains an equipment-grounding conductor wire and a 3-prong 

plug with a grounding pin. The plug 

MUST be plugged into a matching 

receptacle that is properly installed and grounded in accordance with 

ALL local codes and ordinances. 

DO NOT MODIFY THE PLUG PROVIDED. If it will not fit the recep-

tacle, have the proper receptacle installed by a qualified electrician.

IMPROPER CONNECTION of the power cord can result in risk of elec-

tric shock. If repair or replacement of the electric cord or plug is neces-

sary, DO NOT plug it into an electrical outlet.

CHECK with a qualified electrician or service person if you do not com-

pletely understand the grounding instructions, or if you are not sure the 

tool is properly grounded.