Compex Systems 802.11N Manual De Usuario

 

Fig 2.4 Basic Wireless Settings (Station/Station WDS) 

This options below are only available in Station, Station WDS and Repeater WDS modes 

unless otherwise stated. 

Wireless Mode: Station 

 

This is the Service Set Identifier used by station to seek and connect to the access point 

 

of same the SSID identifier.

 

 

   

 

Site Survey will search for the available wireless networks in range on all the supported 

 

channels and will allow you to select one for association. In case the selected network 

 

uses encryption, you’ll need to set security parameters in wireless security section. Click 

 

Scan to re-scan the Access Points in range. Select the Access Point from the list and click 

 

Close this window. Site Survey channel scan list can be modified using the Channel Scan 

 List 

control. 

 

 

Enter the MAC address of the remote access point the device is connected to. This option 

 

will make device only connect to this access point. This is important when connection is 

 Point-to-Point 

operation. 

 

Enter the preferred MAC address of the access point you want device to connect when it 

 

first startup. Up to max of 4 MAC addresses can be entered. Priority is from top to    bottom. 

 

In the event all preferred MAC addresses are not available, device will then pick the 

 

matching SSID access point with the strongest signal.