Cisco Systems 1.4 Manual De Usuario

Media ports terminate the media between Personal Assistant and the end-user Cisco IP Phones. Add a 
media port for each simultaneous Personal Assistant session you require. For example, if you need 24 
simultaneous sessions, add 24 ports.

After configuring these ports in Cisco CallManager, you must also enter the number of ports in the 
Personal Assistant administration interface (see the 

).

You create media ports as Cisco7960 devices, even if you are using other types of phones in your 
network.

This section contains two procedures for adding media ports. Do the applicable procedure for your 
version of Cisco CallManager:

In Cisco CallManager, select Device > Add a New Device.

From the Device Type drop-down list box, select Phone, and click Next.

From the Phone Type drop-down list box, select Cisco7960, and click Next. The Phone Configuration 
options page opens.

Enter the MAC address, as follows:

Enter the extension number, preceded by an adequate number of nines (as a place holder for all 
unoccupied digits to the left of the extension) so that the end result is a 12-digit number. For example, 
if the extension is 5001, the MAC address should be 999999995001.

From the Device Pool menu, select the applicable device pool.

From the Phone Button Template menu, select Standard 7960.

Click Insert to add the Device.

When you are asked if you want to configure line 1, click OK. The Directory Number Configuration 
page opens.

In the Directory Number field, enter the extension assigned to this port (for example, “5001”).

From the Partition menu, select the phone partition you configured (for example, “Employees”).

From the Voice Mail Profile menu, select NoVoiceMail. (Note that if you do not set this to NoVoiceMail, 
Personal Assistant cannot mark user messages with the sender name.)

From the Calling Search Space menu, select the calling search space configured for Personal Assistant 
(for example, “PACSS”).

Ensure that no values are entered for the Call Forward and Pickup settings.

In the Maximum Number of Calls field, enter 2.

In the Busy Trigger field, enter 1.

Click Add.

Repeat 

 through 

 for each port that you need to add.