Cisco Systems 2200 Manual De Usuario
2-13
User Guide for Cisco Digital Media Encoder 2200
OL-17938-01
Chapter 2 Getting to Know the Cisco Digital Media Encoder 2200
DME Security Best Practices
Tip
Saved changes are lost each time that you perform a factory restore operation. Remember to repeat this
procedure any time that login credentials use factory-defined values.
procedure any time that login credentials use factory-defined values.
What to Do Next
•
If Windows is configured to allow automatic logins, see
.
•
Otherwise, see
.
Other Required Password Maintenance (Only When Autologon Is Configured)
Warning
Never configure Microsoft Windows on your DME to enter login passwords automatically. Doing so
creates a significant security vulnerability in your network.
creates a significant security vulnerability in your network.
If you disregard the warning against allowing automatic logins and you configure them nonetheless, you
must take additional steps to ensure that logins occur as expected after you change the encrypted
auto-logon password that Windows uses.
must take additional steps to ensure that logins occur as expected after you change the encrypted
auto-logon password that Windows uses.
Step 6
Check for errors
Point the DME web browser at http://localhost/encoderswebservice/, and then verify
that the SCX service is available.
that the SCX service is available.
—
Step 7
Harden the web interface
a.
Point your browser to the HTTP address of your DME.
b.
Enter the username and the password, as prompted.
The factory default for each of these is admin.
The factory default for each of these is admin.
c.
Click Log In.
d.
Choose Configuration > My NiagaraPro.
e.
Click the username admin in the NiagaraPro
Properties area.
Properties area.
f.
Enter the current password in the Password field.
g.
Enter the new password identically in both of
these fields:
these fields:
•
New Password
•
Confirm New Password
h.
Click Change Password.
The changed password takes effect immediately.
—
Task
Steps
Notes