Cisco Systems 3.2 Manual De Usuario
9-16
Cisco Wireless LAN Controller Configuration Guide
OL-8335-02
Chapter 9 Configuring Radio Resource Management
Configuring Dynamic RRM
Using the GUI to Configure Dynamic RRM
Follow these steps to configure dynamic RRM parameters using the GUI.
Step 1
Access the Global Parameters > Auto RF page (see
Note
Click Set to Factory Default at the bottom of the page if you want to return all of the controller’s
RRM parameters to their factory default values.
RRM parameters to their factory default values.
Step 2
lists and describes the configurable RRM parameters. Follow the instructions in the table to
make any desired changes.
Table 9-1
RRM Parameters
Parameter
Description
RF Group
Group Mode
Determines whether the controller participates in an RF group.
Options: Enabled or Disabled
Default: Enabled
Group Mode Description
Enabled
The controller automatically forms an RF group with
other controllers. The group dynamically elects a leader
to optimize RRM parameter settings for the group.
other controllers. The group dynamically elects a leader
to optimize RRM parameter settings for the group.
Disabled
The controller does not participate in automatic RF
grouping. Rather, it optimizes its own access point
parameters.
grouping. Rather, it optimizes its own access point
parameters.
Note
Cisco recommends that controllers participate in automatic RF
grouping. However, you can disable this feature if necessary by
unchecking the check box. Note also, however, that you
override dynamic RRM settings without disabling automatic
RF group participation. See the
grouping. However, you can disable this feature if necessary by
unchecking the check box. Note also, however, that you
override dynamic RRM settings without disabling automatic
RF group participation. See the
for instructions.