Cisco Systems 3.2 Manual De Usuario
9-22
Cisco Wireless LAN Controller Configuration Guide
OL-8335-02
Chapter 9 Configuring Radio Resource Management
Configuring Dynamic RRM
Step 3
Click Save Configuration to save your changes.
Step 4
Repeat this procedure to set the same parameter values for every controller in the RF group.
Using the CLI to Configure Dynamic RRM
Follow these steps to configure dynamic RRM using the CLI.
Step 1
Enter one of these commands to disable the 802.11a or 802.11b/g network:
•
config 802.11a disable
•
config 802.11b disable
Step 2
Perform one of the following:
•
To have RRM automatically configure all 802.11a or 802.11b/g channels based on availability and
interference, enter one of these commands:
interference, enter one of these commands:
–
config 802.11a channel global auto
–
config 802.11b channel global auto
•
To have RRM automatically reconfigure all 802.11a or 802.11b/g channels one time based on
availability and interference, enter one of these commands:
availability and interference, enter one of these commands:
–
config 802.11a channel global once
–
config 802.11b channel global once
Signal Measurement
How frequently the access point measures signal strength and how
frequently neighbor packets (messages) are sent, which eventually
builds the neighbor list.
frequently neighbor packets (messages) are sent, which eventually
builds the neighbor list.
Range: 60 to 3600 seconds
Default: 60 seconds
Coverage Measurement
How frequently the access point measures the coverage area and passes
this information to the controller.
this information to the controller.
Range: 60 to 3600 seconds
Default: 180 seconds
Table 9-1
RRM Parameters (continued)
Parameter
Description