Cisco Systems 3.2 Manual De Usuario
10-14
Cisco Wireless LAN Controller Configuration Guide
OL-8335-02
Chapter 10 Configuring Mobility Groups
Configuring Auto-Anchor Mobility
Using the CLI to Configure Auto-Anchor Mobility
Use these commands to configure auto-anchor mobility using the CLI.
1.
Enter config wlan disable wlan-id to disable the WLAN for which you are configuring anchor
controllers.
controllers.
2.
To create a new mobility anchor for the WLAN, enter one of these commands:
–
config mobility group anchor add wlan-id anchor-controller-ip-address
–
config wlan mobility anchor add wlan-id anchor-controller-ip-address
Note
The wlan-id must exist and be disabled, and the anchor-controller-ip-address must be a
member of the default mobility group.
member of the default mobility group.
Note
Auto-anchor mobility is enabled for the WLAN when you configure the first anchor
controller.
controller.
3.
To delete a mobility anchor for the WLAN, enter one of these commands:
–
config mobility group anchor delete wlan-id anchor-controller-ip-address
–
config wlan mobility anchor delete wlan-id anchor-controller-ip-address
Note
The wlan-id must exist and be disabled.
Note
Deleting the last anchor disables the auto-anchor mobility feature and resumes normal
mobility for new associations.
mobility for new associations.
4.
To see the list of controllers configured as mobility anchors for a specific WLAN, enter one of these
commands:
commands:
–
show mobility anchor [wlan-id]
–
show wlan mobility anchor [wlan-id]
Note
The wlan-id is optional and constrains the list to the anchors in a particular WLAN. To see
all of the mobility anchors on your system, enter show mobility anchor.
all of the mobility anchors on your system, enter show mobility anchor.