Cisco Systems AS5400 Instruccion De Instalación
4-5
Cisco AS5350 and Cisco AS5400 Universal Gateway Card Installation Guide
78-13311-01
Chapter 4 T3 Dial Feature Card
Online Installation and Removal (OIR) of the T3 DFC
Figure 4-6
Remove the DFC from the Cisco AS5350
Figure 4-7
Remove the DFC from the Cisco AS5400
Step 10
After you remove the DFC from the chassis, set it aside on an ESD-preventive mat.
Step 11
If a DFC slot on the carrier card is to remain empty, install a blank cover over the open DFC slot to ensure
proper airflow inside the chassis. (See
proper airflow inside the chassis. (See
Figure 4-8
Blank DFC Cover
Installing the T3 DFC
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity. To
see translations of the warnings that appear in this publication, refer to the Regulatory
Compliance and Safety Information document that accompanied this device.
see translations of the warnings that appear in this publication, refer to the Regulatory
Compliance and Safety Information document that accompanied this device.
Note
When you replace a DFC with a new DFC of the same type in the same slot, the system software will
recognize the new trunk interfaces and bring them up automatically. If you replace the existing DFC
with a new DFC of a different type, you will have to reconfigure the system. For configuration details,
refer to the Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide.
recognize the new trunk interfaces and bring them up automatically. If you replace the existing DFC
with a new DFC of a different type, you will have to reconfigure the system. For configuration details,
refer to the Cisco AS5350 and Cisco AS5400 Universal Gateway Software Configuration Guide.
58761
37168
36033