Cabletron Systems CSMIM-T1 Manual De Usuario

!

(Flash) Inserted between characters in a dial string, causes the 
modem to go on hook for 1/2-second and then go back off hook, 
as though you depressed the switch-hook button on your 
telephone. 

(Return to Command State After Dialing) Added to the end of 
a dial string, tells the modem to remain in command state after it 
dials the digits preceding the semicolon. This allows you to enter 
dial strings longer than 98 characters. After the final Dial 
command, the modem tries to establish a connection. To abort 
dialing before you attempt to make a connection, type: 
ATH<Enter>. Each Dial command except the last one must end 
with a semicolon. For example: 
ATD 9,5551234; <Enter>.
OK
ATD 5556789 @ 55512345678 W 344 <Enter>.

(Bong Detect) Detects an AT&T BELLCORE service prompt to 
enter a calling card number and authorization. When the modem 
encounters a “$” modifier within a dial string, it waits to receive 
this “bong” signal. Once it detects it, the modem continues 
processing the dial string. If the time set by register S7 elapses 
first, the modem hangs up and displays NO PROMPT TONE.

Use the following dial modifiers to override the \Nn command 
setting. Placed anywhere in the dial string, these modifiers cause 
the modem to override the \Nn setting for that connection only. 
For example, if your modem is set for \N3 (auto-reliable) for 
answering and you are calling a modem that you know does not 
support error correction, use the Z dial modifier to force normal 
mode: ATD 5551234Z <Enter>.

(Dial in LAPM Mode) Placed anywhere in the dial string, causes 
the modem to override current operating mode and dial in LAPM 
reliable mode for the current connection only. 

(Dial in LAPM Mode with Fallback to Normal) Placed 
anywhere in the dial string, causes the modem to override current 
operating mode and dial in LAPM reliable mode with fallback to 
normal mode for the current connection only.