Cabletron Systems CSMIM-T1 Manual De Usuario

 

There are 7 indicators to show system activity and status.

 

The amber 

 

 LED is on when the module requires operator 

attention, and flashes when a problem is detected.

 

The green

 

 LED is ON after the module passes the core power-up 

diagnostics. This LED also flashes while the module is in a reset state.

 

The green 

 

 LED flashes when the module successfully transmits or 

receives data over the MMAC Ethernet backplane channel.

 

When the green 

 

LED is ON steady, the module is in the SET UP 

mode and the user can input configuration data via the console port prior 
to booting the operational software. 

When the module is in the RESET mode (press and hold the SET UP 
button for 3 seconds) the green LED will flash while the CSMIM-T1 
executes power up diagnostics.

 

There are three green LEDs that indicate the Ethernet channel 
(A, B, or C) that is selected by either the software or by jumper 
configuration. 

 

The SET UP Switch allows the user to change the operational mode of the 
module from normal to set up. When the module powers up, it 
automatically enters the normal mode. To enter the SET UP mode, the 
SET UP switch must be depressed within 30 seconds of power-up. When 
the S/U LED lights, the unit is in the SET UP mode.

Depressing the SET UP Switch at any time for approximately three 
seconds causes the module to enter a RESET state. This is the equivalent 
of a reboot. The green S/U LED will flash while the unit executes power 
up diagnostics, and the SET UP mode can be entered.