Cable Electronics 1001ST Manual De Usuario
1001ST
This unit allows any stereo Audio/Video source, to distribute Audio and
Video to different locations over standard coax cable. The RF output can
be changed to any channel between 14 to 69 or cable channels from 65
to 125 ( 95-99 not included).
Video to different locations over standard coax cable. The RF output can
be changed to any channel between 14 to 69 or cable channels from 65
to 125 ( 95-99 not included).
SPECIFICATIONS
VIDEO
Nominal Input level:
Nominal Input level:
1 Volt peak to peak
Input Impedance:
75 ohms
Isolation port to port:
32 dB
Isolation out to input:
60 dB
Video bandwidth:
> 4 Mhz
AUDIO
Nominal Input level:
Nominal Input level:
1 Volt peak to peak
Input impedance:
22k ohm
THD:
< 0.5%
Frequency Response:
20Hz to 14kHz
Channel Separation:
>30dB
Signal to Noise:
>60dB @ 2 Volts
POWER
Requirement: External 9 Volt DC @ 250mA (minimum) with a 2.5mm
Coaxial Center positive connector. Power Supply is included.
Requirement: External 9 Volt DC @ 250mA (minimum) with a 2.5mm
Coaxial Center positive connector. Power Supply is included.
WARRANTY
Cable Electronics, Inc. warrants this product to be free from defects in material and
workmanship, under normal use and service, for a period of one year from the purchase by
the original purchaser. If this product is defective or malfunctions, Cable Electronics will
replace or repair this unit (at their option) within a reasonable time. No expressed or implied
warranty is made for any defects caused by immersion or exposure to liquids, abuse,
neglect, improper operation of unit, excess wear and tear and defects resulting from
unauthorized disassembly and or modification.
workmanship, under normal use and service, for a period of one year from the purchase by
the original purchaser. If this product is defective or malfunctions, Cable Electronics will
replace or repair this unit (at their option) within a reasonable time. No expressed or implied
warranty is made for any defects caused by immersion or exposure to liquids, abuse,
neglect, improper operation of unit, excess wear and tear and defects resulting from
unauthorized disassembly and or modification.
NOTE:
*Please allow one channel spacing above and below the modulator tuned channel
to prevent interference to existing channels.
*Press and hold the mode button to change the frequency output mode. Hold for
at least 6 seconds or until display changes.
to prevent interference to existing channels.
*Press and hold the mode button to change the frequency output mode. Hold for
at least 6 seconds or until display changes.