Bacharach Fyrite Classic Manual De Propietario

Instruction 0011-9026 

Page 7

10.  This step completes CO

2

 or O

2

 FYRITE gas sample analysis. A few points to re-

member when reading the FYRITE:

(a)  FYRITE accuracy is within ±1/2% CO

2

 or O

2

 compared to actual value.

(b)  Always handle FYRITE by fi ns to ensure body heat is not absorbed by fl uid.

(c)  A delay in reading of 5 or 10 seconds may decrease accuracy of reading 

slightly but longer delays may cause substantial error.

(d)  The FYRITE is calibrated to indicate on a “dry” basis for fl ue gas samples, 

which are normally fully saturated with moisture. Failure to artifi cially 

moisten wool packing in Filter Saturator Tube when actual sample is not 

fully saturated will cause FYRITE to read slightly low.

 

Therefore, make certain wool packing in Filter Saturator Tube is suffi ciently 

moistened with water for accurate results on non-fl ue gases. Avoid excessive 

moisture which can be drawn into the Aspirator Bulb and forced into the 

FYRITE during sampling.

FYRITE Fluid strength can be conveniently checked immediately after the fi rst 

sample reading. Without venting, repeat the absorbing operations (Steps 7 through 

9) by inverting FYRITE again and positioning upright until all fl uid drains to the bot-

tom reservoir. Observe scale reading. An increase of more than 1/2% CO

2

 or O

2

 in the 

second reading as compared to the fi rst indicates a need for fl uid replacement.

Locate top of fl uid column (refer to Fig. 11). The surface at the top of the fl uid column 

(meniscus) in the small, center bore will be dish-shaped as shown in Figure 11. Either 

the high or low point of this dish- shaped surface may be used to locate top of fl uid col-

umn providing the same point is always used both for setting scale zero and reading 

percent CO

2

 or O

2

. Obviously, using high point for one operation and low point for the 

other will cause an error.

Best practice is to use high point of this fl uid surface just at the small center bore 

wall. In setting scale zero or reading percent CO

2

 or 0

2

, hold FYRITE vertically and 

level with eyes and sight across scale to top of fl uid column.