Brady 200M Manual De Usuario
Removing Used Ribbon
To remove used ribbon, refer to Figure 2.7 and follow the steps
below.
below.
1. Pull the hook out slightly, then rotate the hook back-and-forth
several times as shown and remove it from the spindle.
2. Grasp the used rib-
bon and remove it
from the Ribbon
Take-Up Spindle.
from the Ribbon
Take-Up Spindle.
3. Remove the
empty core from
the Ribbon Sup-
ply Spindle.
the Ribbon Sup-
ply Spindle.
4. Follow the Rib-
bon Loading pro-
cedure on page
2-4 to load the
new ribbon.
cedure on page
2-4 to load the
new ribbon.
Initial Printer Power Up
After you finish loading the ribbon and media, continue reading
through Sections 3 and 4. Perform the following initial printer
power-up steps as you come to them:
through Sections 3 and 4. Perform the following initial printer
power-up steps as you come to them:
1. Power ON Self Test (POST)
2. Calibration
Subsequent power-ups will not necessarily require step 2 to be
performed. See Sections 3 and 4 for further information.
performed. See Sections 3 and 4 for further information.
Figure 2.7 Removing Used Ribbon
In
st
al
la
ti
o
n
M-Series User s Guide
Installation
2-11