Brocade Communications Systems Brocade ICX 6650 53-1002599-01 Manual De Usuario

Replacing fan trays

5

CAUTION

Disassembling any part of the power supply and fan assembly voids the warranty and regulatory 
certifications. There are no user-serviceable parts inside the power supply and fan assembly.

Determining the need to replace a fan assembly

Enter the show chassis command in the command line interface to display fan status.

Time and items required

Replacing a fan assembly in the Brocade ICX 6650 should take less than two minutes to complete.

You need the following items to replace a fan assembly in the Brocade ICX 6650 switch:

•

A new fan assembly (must have the same part number and the same airflow label as the fan 
assembly being replaced; refer to 

 on page 41 for the location of the airflow label)

•

A #1 Phillips screwdriver

Replacing the fan assembly

Complete the following steps to replace a fan assembly in a Brocade ICX 6650 switch.

1. Using the Phillips screwdriver, unscrew the captive screw on the fan assembly.

2. Before opening the package that contains the new fan tray, touch the bag to the switch casing 

to discharge any potential static electricity. It is recommended that you wear an ESD wrist strap 
during installation.

3. Remove the fan tray from the anti-static shielded bag.

4. Ensure that the replacement fan assembly has the same part number and airflow label as the 

fan assembly being replaced.

5. Remove the fan assembly from the chassis by pulling the handle on the fan assembly out and 

away from the chassis.

6. Holding the fan tray level, guide it into the carrier rails on each side and gently push it all the 

way into the slot, ensuring that it firmly engages with the connector.

7. When you are sure the fan tray has properly engaged the connector, tighten the retainer screws 

to secure the fan tray in the slot.

CAUTION

Do not force the installation. If the fan assembly does not slide in easily, ensure that it is correctly 
oriented before continuing.

NOTE

The fans are controlled automatically by the device.