Whirlpool WFW9151YW Instruccion De Instalación

Run water through both faucets and inlet hoses, into a laundry 

tub, drainpipe, or bucket, to get rid of particles in the water 

lines. 
Check the temperature of the water to make sure that the hot 

water hose is connected to the hot water faucet and that the 

cold water hose is connected to the cold water faucet.

Snap either end of the drain hose form to the drain hose at the 

point where the corrugation begins (A). Bend the drain hose to 

form and snap into place (B).

Place hose into standpipe (shown in picture) or over side of   

laundry tub.

IMPORTANT: Only 4

1

/

2

" (113 mm) of drain hose should be 

inside standpipe; do not force excess hose into standpipe or 

lay on bottom of laundry tub. Drain hose form must be used. 

Insert new flat washers (supplied) into each end of the inlet 

hoses. Firmly seat the washers in the couplings.

Attach hose to hot water faucet. Screw on coupling by hand 

until it is seated on washer. Use pliers to tighten couplings an 

additional two-thirds turn. Repeat this step with second hose 

for cold water faucet.

IMPORTANT: Do not overtighten or use tape or sealants on 

valve when attaching to faucets or washer. Damage can result.

HELPFUL TIP: Make note of which hose is connected to hot 

water to help in attaching hoses to washer correctly. In most 

standard configurations, hoses will cross over each other when 

attached correctly.

Washer must be connected to water faucets with new inlet 

hoses (A) with flat washers (B) (not provided). Do not use old 

hoses.
NOTE: Both hoses must be attached and have water flowing 

to inlet valves. For optimal performance, hot and cold water 

must be supplied to the washer.

Drain

hose form