Whirlpool W10254494A - SP Manual De Usuario

First try the solutions suggested here or visit our website at www.whirlpool.com/help  

for assistance and to possibly avoid a service call.  

Sud (Excess suds)  

appears in display

Excessive suds in washer. Washer is 

running a suds reduction routine. 

Allow the machine to continue. Use only HE detergent.  

Always measure detergent, and base detergent quantity on  

load size. Follow detergent manufacturer’s instructions. 

Press POWER once to clear the code. Then press POWER 

again to restart washer. If code appears again, call for service.

F8E1 (water supply  

error) appears in display

Check for proper water supply.

Both hoses must be attached and have water flowing to the 

inlet valve.

Both hot and cold water faucets must be on.

Inlet valve screens on washer may be clogged.

Remove any kinks in the inlet hose.

F9E1 (drain pump  

system error) appears  

in display

Check plumbing for correct drain  

hose installation. Drain hose extends 

into standpipe farther than 4

1

⁄

2

"  

(114 mm). 

Check drain hose for proper installation. 
Make sure the drain hose is not kinked, pinched, or blocked. 
Remove any clogs from drain hose.
Use drain hose form and securely attach to drainpipe or tub.
Lower drain hose if the end is higher than 96" (2.4 m) above  

the floor.

F5E2 (door will not lock) 

appears in display

Washer door not locking.

Press POWER/CANCEL to cancel the cycle. Make sure the 

door is closed completely and latching. Check for items in  

the washer drum that may be keeping the door from closing 

completely.

Washer beeps when 

START/PAUSE is 

pressed. 

Door not closed.

Close the door completely.

F7E1 (motor drive error) 

appears in display

Motor is having difficulty turning  

the drum.

Washer is overloaded. Remove some items. See “Cycle Guide” 

for load size recommendations.  

Make sure that all shipping materials have been removed. See 

the Installation Instructions. 

“rL” (remove load)  

appears in display

Load detected in drum during Clean 

Washer with AFFRESH

™

 cycle.

Remove items from drum and restart Clean Washer  

with AFFRESH

™

 cycle.

Washer making error 

beeps.  

Door has not been opened and closed 

for at least 3 cycles.

This code may appear when the washer is first turned on.  

Open and close the door to clear the display.

Once any possible issues are corrected, press POWER once to clear the code. Reselect and restart the cycle.

F#E# code other than 

as described above  

appears in display

System error code.

Press POWER once to clear the code. Then press POWER 

again to restart washer. If code appears again, call for service.

Not using HE detergent or using too 

much HE detergent.

Use only HE detergent. Always measure detergent and follow 

manufacture’s directions based on load size and soil level.