Stow Model Vehicle T-20H Manual De Usuario

1.

Read safety instructions at the
beginning of manual.

2. Place pump as near to water as

possible, on a firm flat, level surface.

3. To prime pump, remove fill cap (Figure 2) and fill pump casing

with water. If the pump casing is not filled with water before
starting, it will not begin pumping.

4. Check for 

leaks between pump and engine. If water is leaking

between the pump and engine housing, the seal inside the
pump may be worn or damaged. Continued  operation of the
pump is not  recommended. Further usage of the  pump under
these conditions may cause severe water damage to engine.

1. Check that all hoses are

 securely attached to the pump.

Make certain suction hose (Figure 2) does not have any air
leakage. Tighten hose clamps and couplings as required.

2. It is recommended that  2  clamps be used when securing the

suction hose to the inlet side (suction) of the pump.

3. Remember suction hoses must be 

rigid  enough not to

collapse when the pump is in operation.

4.

Check that

 the discharge hose (Figure 2) is not restricted.

Place hose so that  it  lays as  straight as it is possible on the
ground. Remove any twists or sharp bends from hose which
may block the flow of water.

Pump casing 

must  be filled with water

before using pump. Otherwise pump will
not be able to begin pumping.

DO NOT open

 fill cap if pump is hot! Water

inside may be under pressure.

Suction and discharge hoses are
available from Multiquip. Contact
your nearest dealer for more
information.

5.

The discharge hose is usually a 

collapsible  (thin-walled)

hose, however if a thin-walled discharge hose  is not avail-
able, a rigid suction hose can be substituted in its place.

6.

Make sure  the

 suction strainer  (Figure 2) is clean and

securely attached to the water end of the suction hose. The
strainer is designed to protect the pump by preventing large
objects from being pulled into the pump.

The 

strainer should be positioned so it will

remain completely 

under water. Running the

pump with the strainer above water for long
periods can damage the pump.

DO NOT pump flammable fluids, corrosive
chemicals or fluids containing toxic substances.
These fluids can create potentially dangerous
health  and environmental hazards. Contact
local authorities for assistance.

This pump uses a water-cooled 

seal to prevent water from seeping into the
engine. The passage of water through the
pump casing lubricates the seal and prevents
it from overheating. 

NEVER! operate the pump

without water in the casing as this will cause
damage to the mechanical seal.